How To Apply
STEP 1. Measure the square footage of your driveway to determine the total amount of BioSEALSAFE™Resurfacer for coverage.
STEP 2. Hand Application will require a long handle paint roller and brush or a long handle squeegee. For best coverage and saving time we recommend using an 18” wide, 3/8” nap long handle paint roller.
STEP 3. Clean the driveway surface before applying the coating. Loose dirt, leaves, sand or stones must be removed. We recommend using a stiff brush, long handle broom and blower. Remove any planters or other debris. No ponding water, surface must be dry.
STEP 4. Begin by mixing thoroughly and pouring small amounts directly on the surface. Start from the furthest point from the street moving parallel to the house. Allow the first coat to dry. If you are applying a second coat, do so perpendicular to the first coat. Do not dilute and only apply at a min. temperature of 50 F. Note: If your driveway is relatively smooth with minor cracking, you may only need one coat. If your driveway is more rough or porous, two coats may be required for maximum protection.
Watch for application instructions
How to determine how much you will need
First, measure the square footage of your driveway. Then, determine the number of buckets you will need for one or two coats. Each bucket will give you up to 760 sq.ft. for one coat and 380 sq.ft. for two coats. If your driveway is relatively smooth with minor cracking, you may only need one coat. If your driveway is more rough or porous, two coats may be required for maximum protection.